I checked on an internal system here
using mpirun and it is working as expected,
The one I used here has driver 245 vs
your 202, but this is so fundamental
that should have been working all along
and I think it is based on all the previous discussions
on BGLMPI_ etc.
Either you or Susan may want to run
an mpirun directly to verify if this is an mpirun problem,
....
COUNTER1 is set to XYZ
COUNTER1 is set to XYZ
COUNTER1 is set to XYZ
COUNTER1 is set to XYZ
COUNTER1 is set to XYZ
...
Regards, Hari
Hari Reddy
ISV Parallel Enablement
IBM High Performance Computing Solutions Development
IBM Systems and Technology Group
Tel: 817-962-6472 (T/L 522-6472)
hari@xxxxxxxxxx
Narayan Desai <desai@xxxxxxxxxxx> Sent by: owner-discuss@xxxxxxxxxxxxxxx
09/11/2005 10:04 AM
To
Sameer Shende <sameer@xxxxxxxxxxxxxx>
cc
discuss@xxxxxxxxxxxxxxx
Subject
Re: [bgl-discuss] environment
variables
I have managed to replicate this, and it appears that
everything is
getting passed through cobalt properly. It appears that mpirun isn't
handling environment variables in the same way that it used to. We
will need to talk to IBM about this one.
-nld
- --------------------------------------------------------------------
To add or remove yourself from this mailing list, use the 'notifyme'
command on any BGL machine. To remove: notifyme -n, to add: notifyme -y.